fasadplus.blogg.se

Restrictions for Configuring Distribution System PortsĬontroller configuration in access mode is not supported. This section contains the following subsections:Ī distribution system port connects the controller to a neighbor switch and serves as the data path between these two devices. controllers have two types of ports:įor a comparison of ports in different controllers, see. Adding an Interface Group to a WLAN (CLI)Ī port is a physical entity that is used for connections on the controller platform.Adding an Interface Group to a WLAN (GUI).Viewing VLANs in Interface Groups (CLI).Adding Interfaces to Interface Groups (CLI).Adding Interfaces to Interface Groups (GUI).Restrictions on Configuring Interface Groups.Configuring the AP Manager Interface (CLI).Configuring the AP-Manager Interface (GUI).Restrictions for Configuring AP Manager Interface.Restrictions on Configuring Dynamic Interfaces.Prerequisites for Configuring Dynamic Interfaces.Configuring Service-Port Interfaces Using IPv6 (CLI).Configuring Service-Port Interface Using IPv6 (GUI).Configuring Service-Port Interfaces Using IPv4 (CLI).Configuring Service-Port Interfaces Using IPv4 (GUI).Configuring the Management Interface (CLI).Configuring the Management Interface (GUI).Restrictions for Configuring Interfaces.Choosing Between Link Aggregation and Multiple AP-Manager Interfaces.Configuring Neighbor Devices to Support Link Aggregation.

Verifying Link Aggregation Settings (CLI).Restrictions for Configuring Distribution System Ports.Client Traffic Forwarding Configurations.Connecting Mesh Access Points to the Network.